Installation - Panasonic NR-BL268 Operating Instructions Manual

Installation

The distance from the wall is installed
The top of the refrigerator and the ceiling at least 30 cm.
z z
The back of the refrigerator and the wall at least 10 cm.
z z
The side of the refrigerator and the wall at least 5 cm.
z z
Area around installed
● Do not locate the refrigerator in a humid place as rust may form and
may cause electric leakage.
● Do not locate the refrigerator exposing to direct sunlight as the heat
and sunlight will increase the temperature.
● Do not locate the refrigerator near heat source such as
cooking stove or oven.
● Do not block the openings around the refrigerator.
● The refrigerator must be located in the place where there is good air circulation.
● In case of placing the refrigerator on an uneven surface, adjust the
adjustable bolt to make the refrigerator stands stably.
Moving or shifting
When moving or shifting the refrigerator, remove ice cube tray, box ice tray, chilled case,
z z
pan water evap etc. and check to be sure that there is no water in the refrigerator.
Transport in vehicle in an upright position.
z z
Power cord setting
● To bring power cord for use, pan water evap from left should be lifted up. Then bring the power cord out and
then insert pan water evap into the block by pressing at both the sides.
LED lamp and Grounding
The refrigerator LED lamp, specially designed for this refrigerator, and is not User replaceable. If you need
z z
replacement, please contact Panasonic Authorised Service Center.
If there is no grounding wiring plug in refrigerator, it should be connected with grounding connection to prevent
z z
electrical hazard.
SPECIAL FEATURE
1) ECONAVI
The microchip performing ECONAVI mode is integrated into the main control board. By detecting
refrigerator's frequency of use (opening and closing of door), ECONAVI mode automatically operates
to save energy.
2) INVERTER
In accordance with temperature change inside the compartment, the motor runs at different speed.
When the temperature is stable, the motor runs at a lower speed (energy saving & lower noise). When
powerful cooling is required, the motor runs at a higher speed.
4
10 cm
5 cm