Pioneer S-DW1-K Operating Instructions Manual page 6

CONNECTION
CONNECTION 2
Remove
the speaker cord connecting your amplifier or
re-
ceiver. Twist the ends of
the speaker cord
and parallel-wire
cord
together and connect again. Make sure
that two cords
are
connected to
the speaker terminals.
Amplifier or receiver
S.DW1-K
NOTE:
ll
your amplifier
or
receiver
has
two pairs of
speaker outputs
(A, B),
the two
parallel-wire cords may be connected to a terminal other
than the terminal already connected.
ln
this
case, set the speaker
switch
to "A +
B"
"A,
8".
But the
speakers will not operate normally
if
they are
connected
to a
receiver or
amplifier with terminals A and
B
connected
in
series.
CONNECTION 3
Use the
attached pin-plug cord to connect
the SUBWOOFR
OUTPUT
terminal on the amp or receiver with the
S-DW1-K
LOW LEVEL INPUT terminal.
At this time make sure that
the
terminal is
securely
connected. Also, do not connect
any
equipment to the HIGH LEVEL INPUT
terminal.
Amptifier
or receiver
Speaker system
Speaker system
Two parallel-wire cords
@@.
66
9q
@@
6