Se Ay Of The Receiver Se; Display "Receiver - GRAUPNER GR-12L Manual

Se ay of the receiver se

Display "RECEIVER"

12 / 20
The receiver-side menus can be viewed and some
using a suitable HoTT transmi er or the SMART-BOX. You can
out how to open the menus of a receiver in the "Telemetry"
of the corresponding manual as well as a detailed descrip
receiver menus on the r
com on the Internet.
Note
The values shown in the following display illustra
the standard values.
VO T
If "SERVO" or "SENSOR" is visible in the "CH5 FUNCTION" line
described below, the opera
tored via the limit value set in the v
If "BATT-V" is visible in the "CH5 FUNCTION" line described below,
the opera voltage of the drive ba ery connected via "BATT-V"
is monitored via the limit value set in the value
VOLT".
In both cases, the actual voltage is shown in the transmi
in the "Receiver voltag
If the voltage drops under the set limit value, a transmi er-side
alarm takes place in the form of an acous
/ short).
Adjustment range: 2,5 ... 22,5 Volt in 0,1 Volt steps.
This op monitors the receiver temperature. If the set limit is
exceeded, a transmi er-side alarm takes place in the form of a con-
Adjustment range: 30 ... 80 °C
PERIOD
In this line, specify the periods for the individual channel pulses. This
se ransferred for all control channels.
If your system is used exclusively with digital servos, you can set a
cycle (frame rate) of 10 ms. If your system includes some or
uses exclusively analogue servos, always select 20 ms since the ana-
logue servos may be overloaded and respond by "ji ering" or "growl-
ing".
Adjustment range: 10 or 20 ms
ve product page at www.graupner.
always show
voltage of the receiver is moni-
signal (interval beep long
changed
of the
VOLT".
of "ALARM
display
S1012_GR-12L_DE_V1sh