Wolf CWL-300 Installation Instructions Manual page 5

Assembly option PCB
7 Slide the fan unit forward from the appliance far enough to
access the basic pcb.
8 Mount the 6 pcb feet that came with the option pcb. Then
press the option pcb on the pcb feet and connect the 2
cables from the option pcb to the basic pcb (connector X12
and X13; see also §9.4 in the installation instructions CWL
300/400). Connect the desired options to the option pcb;
the top panel and feed the additional cables through those
out of the appliance.
2.2 Connections option pcb
5442-0
Heat Recovery unit CWL-300(B) / CWL-400(B) with option PCB
9 Slide the fan unit back into the appliance.
11 Place the heat exchanger back into the appliance.
the exchanger.
15 Switch on the appliance on the control panel (simultane-
ously press keys "OK" and "+" for 3 seconds).
dication must be reset by pressing key "OK" for 1 second.
The moment the option pcb is connected, it will automatically
be detected by the basic pcb.
A = Switching input for incident
C = Programmable make contact P1
D = Programmable make contact P2
E = Temperature sensor postheater
F = Input moisture sensor
G = Input CO sensor
2
J = Fuse postheater 4AT
K = Switching output postheater
L = Switching output preheater
M = Fuse preheater 4AT
Chapter 2
5383-0
-
5