ALDI WORKZONE TITANIUM+ PLASMA 35 Instruction Manual page 8

GENERAL SAFETY WARNINGS
PLASMA CUTTER
risk. Make sure that the area around the work piece is clear
of all inflammable materials. It is advisable to have a fire
extinguisher to hand.
5.4 WORK AREA
Ensure a clear work area with unrestricted movement for the
operator. Always maintain easy access to the On/Off switch
and the mains supply.
5.5 THE WORK PIECE
The work piece will remain at a high temperature for a
relatively long period. Do not touch the weld or the work
piece unless you are wearing welding gloves. Always use
pliers or tongs. Never touch the welded material with bare
hands until it has been allowed to cool.
5.6 WORK SURFACES
Do not cut containers or pipes that hold, or have held,
flammable liquids or combustible gases.
Do not coated, painted or varnished surfaces as the coatings
may ignite and or can give off dangerous fumes.
5.7 VENTILATE THE WORK AREA
Plasma cutting emits fumes which can be dangerous. Make
sure that the work area is well ventilated.
5.8 AVOID ELECTRICAL CONTACT
Use adequate electrical insulation with regard to the
electrode, the work piece and any accessible earthed metal
8
1300 777 137
AFTER SALES SUPPORT service@actionspares.com.au
AUS PLASMA 35 60485 04/2018