ALDI WORKZONE TITANIUM+ PLASMA 35 Instruction Manual page 10

GENERAL SAFETY WARNINGS
PLASMA CUTTER
5.13 SAFETY GLASSES
After cutting use safety glasses when brushing, chipping
grinding the slag from the cut.
5.14 OTHER PERSONS
Ensure that other persons are screened from the welding arc
and are at least 15 metres away from the work piece. Always
ensure that the welding arc is screened from onlookers,
or people just passing by. Use screens if necessary, or non
reflecting curtains.
5.15 KEEP CHILDREN AND ANIMALS AWAY
Do not let children or animals have access to the cutting
equipment or to the work area.
5.16 SWITCHING OFF
When you have finished cutting switch off the plasma cutter.
Do not put the torch down with the plasma cutter switch On.
When leaving the plasma cutter unattended, move the On/
Off switch to the Off position and disconnect it from the mains
supply. Do not leave hot material unattended after cutting
5.17 CABLES
Keep the cables, earth clamp and torch in good condition.
Failure to can result in a poor cut and damage to the cutting
torch.
5.18 CHECK DAMAGED PARTS
Before further use of the plasma, any part that is damaged
should be carefully checked to determine that it will operate
10
1300 777 137
AFTER SALES SUPPORT service@actionspares.com.au
AUS PLASMA 35 60485 04/2018