Wi-Fi Protected Setup - Linksys PLWK400 Setting Up A Wireless Network


Flashing slow- Pairing

Solid- Connected to Powerline network
ETHERNET:

Off- Not connected to Ethernet network

Flashing- Send/Receive data

Solid- Connected to Ethernet network
POWER:

Off- Device power off

Solid- Device power on and ready

Flashing fast momentarily- Factory default, Device wakeup from standby mode

Flashing fast indefinitely- Pairing error/system error

Flashing slow- Device in standby mode
WIRELESS:

Off- The Wireless LED lights off when the wireless feature is disabled

Solid- The Wireless LED lights up when the wireless feature is enabled

Flashing- Send/Receive data
WI-FI PROTECTED SETUP™:

Off- The WPS LED lights off when the WPS feature is disabled

Solid- this LED flashes while a wireless network device is connecting with your PLW400
using Wi-Fi Protected Setup™

Flashing- The LED flashes when a WPS session is active
FIRMWARE UPGRADE METHOD
1. How do I upgrade the firmware on the PLW400?
There are two (2) ways to upgrade the firmware of your powerline adapter:

Using the Linksys Powerline AV Utility - Launch the utility and under Network Status
tab, select PLW400. Go to the Administration tab then click on the Upgrade button
under Firmware Upgrade.

Using the web-based set-up page - Access the web-based setup page and go to
Administration tab > Firmware Upgrade sub-tab. Click on the Browse button and
look for the firmware file you have downloaded then click the Start Upgrade button.
SPECIAL FEATURES
1. What is the transfer rate of the PLW400?