Dell Alienware Area-51m R2 Service Manual page 66

6. Remove the solid-state drive from M.2 slot
7. Remove the solid-state drive from M.2 slot
8. Follow the procedure from step 1 to step 4 in
9. Remove the solid-state drive from M.2 slot
10. Remove the solid-state drive from M.2 slot
11. Remove the solid-state drive interposer
12. Remove the rear-I/O
13. Remove the computer
14. Remove the heat-sink
15. Remove the left power-adapter
16. Remove the graphics card.
17. Remove the processor.
About this task
The following image indicates the connectors on the bottom side of your system board.
1. Power-button board cable
The following image indicates the connectors on the top side of your system board.
1. Coin-cell battery cable
66
one.
two.
Removing the hard
three, if applicable.
four, if applicable.
board, if applicable.
cover.
base.
assembly.
port.
drive, if applicable.
2. Card-reader board cable