4
Basic Operations
Switching The Power On/Off
Press the
switch to power on. Press the
PWR
key for 1 second to turn off.
PWR
Adjusting The Volume
Turn the VOL knob clockwise to increase the
audio level, counterclockwise to decrease.
ADJUSTING SQUELCH LEVEL
A squelch eliminates white-noise (the background noise when a signal is
not received). Higher level settings will keep the squelch "closed" more
10
tightly for quieter monitoring, but weak signals will not be heard. Lower
settings allow weaker signals to "open" the squelch but noise may also
cause it to open. By rotating the SQL knob, adjust the squelch level to
the desired level.
Switch between VFO and MEMORY mode
In standby, press
key or Microphone's
key until appear
, this indicates current
frequency in Memory mode. Repeat above
operation to switch between Frequency mode
(VFO) and Memory mode.
PWR KEY
PWR
P2
FUNC
P3
P4
Select the desired receiving frequency or browse channels to listen to
ongoing communications. The S-meter shows
relative signal strength between BUSY and
5th segment when the transceiver detects an
incoming signal.
Press MIC's
desired is not busy. Press Mic's
press and hold [PTT] key to speak into microphone.
Adjusting Frequency/Channel
1.
In frequency (VFO) mode, you can change the current frequency to
the desired one through microphone [
key to increase frequency and press
frequency. In another way you also can directly input the desired
frequency by MIC's numeric keys. Press
digits will be masked. In this status, Microphone [
] key will increase or decrease frequency quickly by 1MHz
step.
2.
In memory mode, you can change the current channel to the
desired one through microphone [
key to the forward channel and press
backward channel. In another way you also can directly input the
desired channel by MIC`s numeric keys. For example, choosing
CH1, press [0] [0] [1] .
Available steps are 2.5K, 5K, 6.25k, 8.33K,10K, 12.5K, 20K, 25K and 30K.
Receiving
Transmitting
key to monitor for a while to confirm the channel
/
] key. Press
key to decrease
key, the KHz order
P2
/
] key. Press
key to the
key to return standby status,Then
/