Hunter Cranbrook Installation Manual page 8

1886
Remove the top liner of the three adhesive strips affixed to the lip of
the interior hood.
bag
Screw two housing assembly screws from the
hardware bag halfway into the motor housing. It
does not matter which two screw holes you choose.
Connect the plugs from the fan and lower switch
housing. Make sure to line up the colored markings
on the connectors.
7
Ceiling Bracket
Assembling the Hood
2 of 3
Light Kit Screw
Feed the wire plug through the center hole of the
hood, then wrap keyhole slots around the screws
and twist counterclockwise.
Install the lower switch housing to the hood using
the three pre-installed capture screws. Tighten all
three screws.
Hanging Fan Wiring
Insert the third screw, found in the
bag, into place and then tighten all three screws.
FAN FALL HAZARD
Make sure the hood is securely attached to the
mounting plate. Failure to properly secure all
3 assembly screws could result in the switch
housing fixture falling.
PRE-INSTALLED
2 of 3
Canopy Blades
PRESS
DOWN
FIRMLY
Light Kit Screw
bag
hardware
WARNING
Install the bulb into the socket. When necessary,
replace with bulb of the same type and wattage.
Light Bulbs
1 of 3
Remote