Toto WASHLET Instruction Manual page 38

Troubleshooting
Warm air drying (SW2034, SW2033R only)
Trouble
The dryer
temperature is low
Stops in the middle
of use
Trouble
The toilet seat is
cold
Trouble
The energy saver
feature is not
working
38
Please check
● Is the dryer temperature set to low level?
● The feature stops automatically after 10 minutes of continuous use.
● Does the seat switch have diffi culty detecting?
➞ Sit back on the toilet seat. If you get up slightly from the seat, or sit forward on
the seat, the seating switch may temporarily stop detecting your presence.
Toilet Seat and Toilet Lid
Please check
● Is the toilet seat temperature set to "OFF" or a low level?
● Is the ENERGY SAVER LED (orange) lit?
 
When the SEAT LED (green) is also lit.
➞The toilet seat temperature has been lowered to save energy. When you sit,
the toilet seat is temporarily heated.
  When the SEAT LED is OFF.
➞Energy saver is operating and has turned off the toilet seat heater. When
you sit on the seat, the toilet seat heater is turned on temporarily and the
seat is warmed in about 15 minutes.
You can turn it "OFF" if the energy saver feature is "ON".
● Have you been seated for a long time?
 
After about 20 minutes of sitting, the temperature starts going down, and
after about 1 hour, the toilet seat heater is turned "OFF".
➞Stand up from the seat and then use again.
● Did you put anything on the toilet seat or the toilet lid?
➞Remove the object from the toilet seat or the toilet lid.
● The seat switch will not turn on unless you sit on the seat properly.
➞Sit back on the toilet seat.
● Is a toilet lid or seat cover installed?
➞Remove any covers.
Energy Saver
Please check
● Because the function takes several days learning the usage conditions before
starting energy saver, the amount of energy saving may be low, depending
on the frequency of use.
➞Check the energy saver feature.
Ref.
Page
18
-
11
Ref.
Page
18
20
-
-
11
11
Ref.
Page
20