4. Close the
PSU
hinge.
5. Install the
Front bezel
6. Install the cover.
7. Follow the procedure in
WLAN module and SMA antenna
Removing WLAN module and SMA antenna
Steps
1. Follow the procedure in
2. Remove the:
a.
Cover
b.
PSU hinge
3. Remove the single M2x3.5 screw that secures the WLAN card to the system board, un-route the antenna cables from the rubber
guides on the system board [1].
4. Slide and remove the external antenna connector from the PCIe slot on the chassis [2].
After Working Inside Your
Computer.
Before Working Inside Your
Computer.
Disassembly and reassembly
49