Step 7: Check The Installation; Step 8: Apply Power And Check The Leds - NETGEAR GS110TUP Hardware Installation Manual

10-Port Gigabit Ethernet Ultra60 PoE++ Smart Managed Pro Desktop and Rackmount Switches
37.) The network connection can be to a hub, another switch, router, or Internet
gateway.
• Model GS710TUP. Connect PoE++, PoE+, PoE, and non-PoE devices to ports 1–8.
Connect either port 9 with an Ethernet cable to your network or port 10 with an SFP
transceiver module and cable to your network. (For information about the SFP
transceiver module, see Optional Step 5: Install an SFP transceiver module on page
37.) The network connection can be to a hub, another switch, router, or Internet
gateway.
The following procedure describes how to connect devices to the switch's RJ-45 ports.
The switch supports Auto Uplink technology, which allows you to attach devices using
either straight-through or crossover cables. Use a Category 5 (Cat 5), Cat 5e, or Cat 6
cable that is terminated with an RJ-45 connector.
Note: Ethernet specifications limit the cable length between the switch and the attached
device to 328 feet (100 meters).
To connect devices to the switch's RJ-45 ports:
1. Connect a device to an RJ-45 network port on the switch.
2. Verify that all cables are installed correctly.

Step 7: Check the installation

Before you apply power to the switch, perform the following steps.
To check the installation:
1. Inspect the equipment thoroughly.
2. Verify that all cables are installed correctly.
3. Check cable routing to make sure that cables are not damaged or creating a safety
hazard.
4. Make sure that all equipment is mounted properly and securely.

Step 8: Apply power and check the LEDs

The switch does not provide an on/off power switch. The power cable connection
controls the power.
Before connecting the power cable to the power receptacle on the switch, select an AC
outlet for the DC power adapter (model GS110TUP) or AC power cable (model
Installation 38 Hardware Installation Guide