Product Overview - Cisco 7010 Replacement Instructions Manual

Product Overview

Product Overview
Following are brief descriptions of the Cisco 7010 and Cisco 7505 routers, the power supply, the fan
tray, and the environmental monitoring functions. The power supply and fan tray exchange
information with the environmental monitoring software, although each operates independently.
Cisco 7010 and Cisco 7505 Overview
Figure 1 shows the interface processor end of the Cisco 7010 chassis.
Note
the same.
In the Cisco 7010, the Route Processor (RP) and Switch Processor (SP) (or the Silicon Switch
Processor [SSP]) are required system components and occupy the two top slots. In the Cisco 7505,
the Route Switch Processor (RSP1) is a required system component and occupies the top slot.
In both chassis, the remaining interface slots (three in the Cisco 7010 and four in the Cisco 7505)
support any combination of available interface types: Ethernet, Token Ring, FDDI, serial, HSSI, and
so forth.
The interface processor end of the router also contains the AC power receptacle, the system power
on/off switch, and the DC OK power status LED, all of which are part of the power supply but
accessible through cutouts in the chassis frame. (See Figure 1.) To the left of the power switch and
receptacle cutout is a ground screw that provides a chassis ground connection for ESD equipment or
a grounding wire.
Figure 1
On/off
power switch
The noninterface processor end of the chassis has a removable panel that provides access to the
internal components discussed in this publication.Two captive slotted fasteners secure the panel.
2 600W AC-Input Power Supply and Fan Tray Replacement Instructions
For the procedures in this publication, the Cisco 7010 and Cisco 7505 chassis are functionally
Cisco 7010—Interface Processor End
AC power
receptacle
Chassis
ground
DC OK
power indicator
Power supply