Do not allow fluff to accumulate around the dryer. • Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons may cause injury or serious malfunctioning. Contact your local Tricity Bendix Service Centre. Always insist on genuine Tricity Bendix spare parts.
Contents For the User Important Safety Information • Installation • Child Safety • Your New Tumble Dryer Description of the Appliance The Control Panel • Programme Chart • Mains-on Light • Low Temperature Button • Start Button • Water Full Indicator Light •...
Your New Tumble Dryer This tumble dryer will give your wash that soft, relaxed feel whatever the weather. Extremely high quality standards both during development and manufacturing guarantee a long service life for your appliance. Maximum economy in the operation of your dryer is achieved through very frugal electricity consumption and short drying times.
The Control Panel 1 Programme Chart This will help you to select the correct time for drying. 2 Mains on Light This lights up when the machine starts operating and goes out when the selector dial is on position “0” and when you open the door of the appliance or the small door covering the condenser at the bottom.
Programme Chart Cottons Selector dial up to 150 minutes (high temperature section) Type of laundry Cotton Towelling Shirts Sheets Hand towels Tablecloths Table napkins (not completely dry; suitable for ironing) Synthetics Selector dial up to 100 minutes (low temperature section) Degree of drying Type of laundry Synthetics or mixed fabrics...
Operating Sequence Before using your tumble dryer for the first time, we recommend you place a few damp cloths inside the appliance and dry for 20 minutes. There may be dust inside a brand new tumble dryer. Drying 1. Connect the appliance. 2.
Hints & Tips on Drying Before placing articles of laundry in your tumble dryer, check the care labels to ensure they are recommended for tumble drying. Care Labels you may find on your laundry may be tumble dried normal drying (high temperature) delicate drying (low temperature) do not tumble dry Do not overload the appliance.
Maintenance and Cleaning You must disconnect the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. External cleaning Use only soap and water and then dry thoroughly. Important: do not use methylated spirit, diluents or similar products.
Clean it with a brush and rinse it under the shower if necessary. Also clean the outside, removing all fluff. Clean the rubber seal round the condenser cabinet and in the inner part of the small door with a damp cloth.
Drying takes too long or laundry is not dry enough. If after the above checks, there is still a fault, call your local Tricity Bendix Service Force Centre. Service & Spare Parts In the event of your appliance requiring service, or if...
Guarantee Conditions Standard guarantee conditions We, Tricity Bendix undertake that if, within 12 months of the date of the purchase, this Tricity Bendix appliance or any part thereof is proved to be defective by reason only of faulty workmanship or...
Installation Instructions It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Technical Specifications DIMENSIONS POWER SUPPLY VOLTAGE TOTAL POWER ABSORBED MAXIMUM RECOMMENDED LOAD DRUM VOLUME...
Unpacking Warning ! Slide out the polythene bag containing the polystyrene block before using the appliance. Pull off adhesive strips from inside machine on top of drum. Should the appliance be moved, it must be transported vertically. Positioning It is recommended that, for your convenience, the machine is positioned close to your washing machine.
Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow - Earth Blue - Neutral Brown - Live The wire coloured green and yellow must be connected to the terminal marked with the letter «E»...