Assembly; How To Use - Ryobi EWD1245 Operator's Manual

ASSEMBLY

Attach small float cage
Turn inner tank upside down.
Place float ball over round opening in bottom of tank.
Snap tabs (A) on float cage into slots (B) on tank
Once in place, do not remove the float
assembly.
NOTE:
Do not attempt to remove the large filter cage or
float ball on cleaner lid.
They are not removable parts.
Insert inner tank
(See Fig.4)
With inner tank duct toward drain side of outer tank,
align tab (C) on inner tank with slot (D) in outer tank;
slide inner tank into place.
Attach cleaner lid
(See Fig.5)
Rotate lid latches (E) outward. With wet/dry selector
(F) toward drain side of tank align ribs (G) on front of
tank with slots (H) on either side of hose inlets; place
lid on tank.
Rotate latches inward to lock lid in place.
Note:
For convenience in attaching and r emoving the
lid, finger holds are provided.
Attach hose, wands and cleaning tool
(See Fig.6)
Push hose into hose intlet on tank; twist hose to
tighten or loosen connection. (See "How to use"
section for pr oper inlet selection.)
The wands and tools attach to hose in the same
manner.
Press squeegee insert firmly into wet/dry nozzle
opening.
(See Fig.7)
Use squeegee for wet pick-up only .
Attach drain cap
(Fig.8)
Screw drain cap (I) onto lower, front of tank as shown.
Additional tools and accessories that ar e not included.

HOW TO USE

Cleaner Description
(See Fig.9)
The assembled Wet/Dry vac will look like the drawing.
Operate cleaner only at voltage specified on rating
label on cleaner lid.
1. ON/OFF switch
2. Cleaner lid
3. Cleaner lid latches
4. Carrying handles
5. Hose inlet
6. Wet/dry selector
ENGLISH
7. Caster Support
8. Casters
9. Tank drain cap
(See Fig.3)
10. Cleaner tank
11. Extension tube storage holders
12. Vacuum nozzle
13. Cord hook: loop cord over hook for storage
14. Blower port
15. Crevice tool
16. Wet/Dry nozzle with squeegee insert
Separate wet / dry tanks
This feature allows the user to change from wet pick-
up to dry pick-up without having to empty the tank or
change filters. Dry debris will collect in the inner tank
and wet debris will collect in the outer tank.
Wear ear protection if operating cleaner for a
prolonged period of time.
Make sure that the small foam and cartridge filters are
in place.
Dry pick-up
Disconnect cleaner from electrical outlet.
With hose removed from cleaner, slide wet/dry selector
(A) to expose "Dry tank inlet" (B). Selector will snap
into place. Insert hose into "Dry tank inlet". Attach the
desired tool to hose end.
Make sure cleaner lid is locked in place.
Plug power cord into a pr operly
grounded outlet and turn cleaner on.
Wet pick-up
Disconnect cleaner from electrical outlet.
With hose removed from cleaner, slide wet/dry selector
(A) to expose "Wet tank inlet" (C). Selector will snap
into place. Insert hose into "W et tank inlet".
- 7 -
(See Fig.10)
(See Fig.11)