Advertisement
A combination antenna receives normal broadcast channels (VHF 2-13 and UHF l4-69). Your connection is easy because there is on
one 75 O (ohm) antenna jack on the side of your TV and that's where the antenna goes.
1
2
3
4
lfyour antenna has a round cable (75 ohm) on the end, then
you'ie ready to connect it to the LCD TV. lf your antenna
has flat, twin-lead wire (300 ohm), you first need to attach
the antenna wires to the screws on a 300- to 75-ohm
adapter(not supplied).
Connect the antenna (or adapter) to one end of the
supplied L-Adapter as shown, and connect the other end of
the L-Adapter to the TV jack on the side ofthe LCD TV
Plug the power cable into AC inlet on LCD TV set. Plug the
oower cable into an outlet and switch TV set on.
Run the AUTO PROGRAM function to set uD the TV for the
broadcast or cable channels available in your area. lf you do
not run the auto program function to set uP the channels ,
your television may not operate properly.
. Remember, an antenna or cable TV signal must first be connected to
your LCD TV
. Please make sure rhat you have selected the TV mode with AV key
on your remote control, before installinsTV channels.
Outdoor oa Indoor Antenna
(Combination vHF JHD
to 300-75Q ad
Your Cable TV input into your home may be a single (75 ohm) cable or use a cable box decod€r. In either case the connection is ver)
simple. Follow the steps below to connect your cable signal to your new television.
1
2
3
The Cabb ry sin
fro.n Cable Comp
75O coaxial cabl€
Direct cable connections:
Connect the Cable TV siSnal to one end of the supplied
L-AdaDter as shown. and connect the other end ofthe
adapter to the TV lack on the LCD TV
Plug the power cable into AC inlet on LCD TV set. Plug the
power cable into an outlet and switch TV set on.
Run the AUTO PROGRAM function to set uD the TV for the
broadcast or cable channels available in your area. lf you do
not run the auto program funcdon to set up the channels ,
your television may not operate properly.
. Remember, an antenna or cable TV signal mustfirst be connected to
your LCD TV
. Please make sure that you have selected the TV mode with AV key
on your remote control, before installing TV channels.
Rear Jack panel of Television
Advertisement
