Inspection Standards - Nikon COOLPIX 2200 Repair Manual

INSPECTION STANDARDS

Item
External view
Gap/Difference in
height
Outside and inside
status
Operation/Operability
Operation
Operability of buttons
Lever/Knob
Operation touch
Each cover
Monitor
Shooting image
• General components
Gap: 0.3mm or less
Difference in height: 0.15mm or less
• When the battery cover is closed:
Gap: 0.5mm or less (Difference between right and left must
not be noticeable.)
• There must be no noticeable damage and soil.
• When pushing the main body, noticeable noise must not be
heard.
(Observe and check it by naked eyes under fluorescent lamp
and natural sunshine.)
• While operating, any irregularities or irregular noise shall not
be required.
(Check it by shaking the camera while operating.
Lightly hit the camera onto the Linoleum-laid desk while
operating.)
• No cave-ins of the buttons shall be required.
• Malfunctions shall not be required.
• Operator must feel "click" on each button.
• "Click" must occur when or after a switch is ON.
(Check it while operating normally.)
• When clicking, normal touch shall be required. Any outstand-
ing "caught-in-mechanism" touch or "rubbed-in-mechanism"
touch or play shall not be required.
(Check and observe the condition through normal operation.)
• When operating a lever or knob by hand, any irregular condi-
tions shall not be required.
(Operate the camera in the actual photography procedure and
check the operation touch.)
• When closed, there must not be an extreme play.
• Each cover can be opened/closed without any outstanding
"caught-in-mechanism" touch or "rubbed-in-mechanism"
touch or abnormal noise.
(Open and close each cover and check it.)
・Inclined degree of image shall be 0.5 degree or less.
・PC monitor and print output
(Output will be evaluated while the display range boundary
of LCD unit is regarded as standard when the through-the-
monitor image is made.)
- R1 ･ E2200 -
Criteria
VAA23001-R.3626.A
Applied tool(s)
Visual observation
Primary battery/
Secondary battery
Photoshop
Printer