Advertisement
CARING FOR YOUR
THERMAL DISPENSER
IMPORTANT
:
DO NOT
overfill or submerge dispenser in water.
DO NOT submerge the funnel assembly in water.
Damage caused by doing this will void the factory warranty.
-Remove the digital funnel assembly from the dispenser.
With normal cleaning, the funnel will operate properly
for many years.
-Wipe the funnel with a damp cloth of warm soapy water.
NOTE: DO NOT SUBMERGE the funnel assembly
in
water or any other liquid.
-Makes sure the gold contacts on the funnel are clean. If
there is coffee buildup on the funnel contacts, use vinegar
to clean them.
-Avoid using very abrasive products to clean the gold
funnel contacts, as this many damage the funnel.
-Before cleaning dispenser, be sure that all of the residual
coffee in the dispenser has been emptied out.
-Fill the dispenser 3/4 full with very hot water.
DO NOT
overfill or submerge the dispenser.
-Add a food-safe cleaning solution like Urnex or Scale
Kleen which should be used according to the packet
instructions. Let solution work for 1-2 hours and then
rinse with warm water and sanitize.
-Do not use any stainless steel polishes or cleaners on
any plastic parts, this will cause the plastic to prematurely
fail, which will not be covered under warranty.
-Do not use abrasive cleaners, brushes or scouring pads
that will damage the stainless steel and / or the plastic
parts.
FETCO and LUXUS are all trademarks or registered trademarks of Food Equipment Technologies Company.
Advertisement
