Advertisement
Initial checks
When the key is turned to MAR-
ON, the display begins a process of
diagnosis for the vehicle's on-board
systems. This may last for a few
seconds. If, with the engine running,
the system does not detect any
faults, the system displays OK.
If the display indicates a fault, see
WARNING LIGHTS AND
MESSAGES in this section.
Speed limit exceeded
(Spd. Lim.)
This function allows the vehicle
speed limit to be set (km/h). When
this is exceeded, the driver is
notified through a dedicated
indication on the display, an acoustic
signal and a warning light (triangle
logo).
This indications are interrupted
immediately when the MODE
button is pressed. The indication on
the display
To set the speed limit, proceed as
follows:
– press the MODE button briefly to
enter the menu;
– press the ▼ button; Spd. Lim. will
appear on the display;
– press the MODE button briefly,
then ▼ or ▲ to select ON or
OFF;
– to activate the function, press the
MODE button briefly when ON
flashes;
– press the ▼ button: a speed value
will appear on the display;
– press the MODE button briefly:
the value will flash;
– set the new values as desired,
corresponding to the new speed
limit, by pressing the ▼ and/or ▲
buttons.
– press the MODE button briefly to
confirm;
– hold down the MODE button to
return to the standard display.
The speed limit can only be set to a
value of 30 km/h (or 20 mph) or
above. Every time the ▼ or ▲
buttons are pressed, the value is
decreased/increased by 5 units
respectively When the buttons are
held down, the value decreases or
increases rapidly, as appropriate. It is
advisable to release the button as
you approach the desired value, then
complete the adjustment with single
presses.
The indication on the display is
interrupted automatically if the
vehicle speed falls below the set
value by at least 5 km/h (or 5 mph).
45
Hide quick links:
Advertisement
