IBM SiteProtector SP3001 Mount Manual page 4

Installing the appliance on the slide rails
CAUTION:
The weight of this part or unit is between 18 and 32 kg (39.7 and 70.5 lb.). It takes two persons to
safely lift this part or unit. (C009)
> 18 kg (39.7 lb)
To install the appliance on the slide rails, complete the following steps as shown in Figure 5.
1. Pull the slide rail forward 1 .
2. Use two people to carefully lift the appliance 2 and tilt it into position over the slide rails so that
the rear nail heads 3 on the appliance line up with the rear slots 4 on the slide rails.
3. Slide the appliance down until the rear nail heads slip into the two rear slots, and then slowly lower
the front of the appliance 5 until the other nail heads slip into the other slots on the slide rails.
4. Make sure that the front latch 6 slides over the nail heads.
Figure 5. Secure the appliance in the rack
5. If the appliance is locked into place, slide the appliance toward you so that you can attach the
brackets with the captive screws.
6. Slide the appliance into the rack, as shown in Figure 6 on page 5.
4
SiteProtector SP3001: Rack Mount Guide
Lift point
Lift point