Removing A Memory Module - Fujitsu PRIMERGY CX122 S1 Service Supplement Manual

4.6.1

Removing a memory module

Ê Open the server as described in
Ê If applicable, remove the CPU 1 air duct as described in
air ducts" on page
Figure 51: Removing a memory module
Ê Eject the defective memory module by pressing out the securing clips at
each end of the memory module connector.
V
CAUTION!
In order to satisfy cooling requirements, please note:
When removing a memory module that is not replaced immediately,
always install a memory dummy module in the empty memory slot as
described in
module" on page
PRIMERGY CX122 S1
Installing / replacing memory modules
section "Opening the server" on page
56.
section "Removing / installing a memory dummy
76!
Service Supplement
31.
section "Removing
73