PAC SK1 Manual

Manual Shift Knob with 4 Button Infrared Stereo Controller
The SK1 is a polished aluminum gear shift knob that replaces most factory manual transmission shift knobs. The SK1 is also a
infrared learning remote that can learn up to 6 functions from most aftermarket stereo's, VCP's, DVD's and Satellite radio's wireless
1
remote. The larger button (Fig. 1) is the 'Dual mode' button which switches the bottom 3 buttons over to second mode which gives
you 3 additional functions.
Step 1: Unpacking
Remove the phillips screw from underneath the package.
Unscrew the bottom cover on the gear knob and remove
the set screws and plastic dowel inside the gear knob.
Step 2: Select gear knob adapter
Remove your existing gear knob from the car. Find the
correct rubber adapter from the three choices and cut off.
Step 3: Installation of gear knob
A: Insert rubber cap into
gear knob.
This step requires that
you insert the rubber cap
into the gear knob very
carefully. Failure to install
properly could cause
damage to the ribbon
cable and failure of the
SK1 module.
B: Straighten the ribbon
cable coming out of the
gear knob to remove
any twists. Pull the cable
out gently to straighten it
if necessary.
techsupport@go2pac.com • Voice: 714-835-3022 • Fax: 714-835-3233 • www.go2pac.com
3-22-02
Important!
Be sure the ribbon cable
inside the gear knob is
straight before inserting the
rubber cap!
Pacific Accessory Corporation - 1502 S. Santa Fe Street, Santa Ana, CA 92705
SK1
C: Insert the rubber cap into the gear knob making sure
that the cable is aligned with the slot on the rubber
cap. This slot provides clearance for the cable after
i n s t a l l a t i o n .
Try to center it
between the set
screws.
D: Using a small
screw driver
push the rubber
cap all the way
into the bottom
of the
knob.
Warning!
Be sure that the cable is clear of the set screws when
tightening. Failure to do so will cause damage to the
ribbon cable and cause malfunction.
Step 4: Install the SK1 controller module
All SK1 wire connections should be made at the same
connector as the aftermarket stereo. Connect the SK1
black wire to chassis ground and the red wire to 12 volts
switched accessory. Run the 5 pin ribbon cable down
the gear shaft and through the boot cover up to the SK1
module. Connect the 5 pin ribbon cable of the gear knob to
the SK1 module (Fig. 1). Do not mount the IR emitter until
after programming and verifying operation on next page.
5 pin ribbon cable and plug
Switches from 1st mode
to 2nd mode
M
o
d
e
1 2
3
Step 3: Continued
gear
SK1
Shift Knob Infrared Stereo Controller
Press Shift
Knob Button
Program Button
Black (-) Ground
Red (+) 12 volts accessory
Fig. 1
Press Function
on IR Remote
IR Input
IR emitter
Page 1