Troubleshooting Guide - Blaupunkt CR67 User Manual

Track Scan
Press SCA to start Track Scan. Track Number blinks during
for 10 seconds. After scanning all tracks on disc, unit advances to next disc. Unit continuously
track
scans until user stops scan by pressing SCA, another playback control or SK. Track Scan
deactivates any previously-active MIX or RPT modes.
Disc Scan
Press and hold SCA for more than 2 seconds to start Disc Scan. Disc Numbers blink during
scanning operation. Unit stops at first track on each disc for 10 seconds. Unit continuously scans
until user stops scan by pressing SCA, another playback control or SRC. Disc Scan deactivates
any previously-active MIX or RPT modes.
Changer Reset
In unlikely case of CD changer trouble, reset CD changer by turning unit's power and'or ignition off,
and then power on unit. (See TROUBLESHOOTING below.)

Troubleshooting Guide

The following check will assist in the correction of most problems which you may encounter with your
unit. Before going through the check list below, refer back to the connection and operating procedures.
General
Trouble
No sound.
Radio reception
Trouble
Preset stations are not receivable.
Automatic tuning is not possible.
Travel Store feature does not complete
storing of six stations.
Also make sure that antenna is connected, extended and dry inside.
l
CD Changer operation
Trouble
CD play does not start.
The disc cannot be loaded or is
automatically ejected.
The sound skips due to vibration.
Error Displays
Display Cause
"CD Err" A disc problem such as an upside
down or dirty disc, or a CD-ROM
(computer) disc.
"No Disc" No magazine or disc in changer
If the above mentioned solutions do not help to improve the situation, consult your nearest Blaupunkt dealer or in
volume
Adjust the
l
With a two-speaker system set the fader control to the center
l
position.
The broadcast is too weak.
l
The broadcast is too weak. --> Use manual tuning.
l
Not enough broadcast frequencies are receivable.
l
Dusty or defective disc.
l
The ambient temperature is more than 50°C (120°F).
l
The disc is inserted with the printed side downwards.
l
The changer is installed at an angle of more than 20".
l
The changer is not installed on the sturdy part of a car.
l
Dusty or defective disc.
l
Solution
Insert the disc correctly.
Clean the disc.
Take out the magazine and insert the discs.
the United States call l-800-266-2528.
Cause/Solution
with the + button.
Cause/Solution*
Cause/Solution
17