Table of Contents
Advertisement
Backguard
• Before installing the cooker, assemble the backguard "C" .
• The backguard "C" can be found packed at the rear of the cooker.
• Before assembling remove any protective film/adhesive tape.
• Remove the two spacers "A" and the screw "B" from the rear of the cooktop.
• Assemble the backguard as shown and fix it by screwing the central screw "B" and the spacers "A".
Figure 9 Assembling The Backguard
Anti-Tilt Bracket
To restrain the appliance and prevent it tipping accidentally, fit a bracket to its rear to fix it
securely to the wall.
To Fit The Anti-Tilt Bracket:
1. After you have located where the cooker is to be positioned, mark on the wall the place where the two
screws of the anti-tilt bracket have to be fitted. Please follow the indications given in Fig. 10.
2. Drill two 8 mm diameter holes in the wall and insert the plastic plugs supplied.
https://producthelp.fisherpaykel.com/eu/Cook/Freestanding_Cookers/Dual_Fuel/OR90LDBGFX3/Install%2F%2FUser_Guide_...
Updated: Mon, 11 May 2020 05:26:38 GMT
Powered by
5
Advertisement
Table of Contents
