Installation - D-Link DWL-2200AP Install Manual

Hide thumbs Also See for DWL-2200AP:

Table of Contents

It's best to use a computer (with an Ethernet adapter) that is connected

to a switch for configuring the DWL-2200AP. The default IP address for

the DWL-00AP is

You will need to assign your computer a Static IP address within the same

range as the DWL-2200AP's IP address for the purpose of configuring the

AP. Please refer to page 13 to statically assign an IP address to your

computer.

There are two methods of powering the DWL-00AP. The power adapter

can plug directly into the unit or plug into the PoE (Power over Ethernet)

base unit. For directions on using PoE, please refer to page 15.

Connect the power adapter to the receptor at the back panel of the

DWL-00AP. Plug the other end of the power adapter to a wall outlet or

power strip. The Power LED will turn ON to indicate proper operation.

Insert one end of the cable to the Ethernet port on the back panel of the

DWL-00AP and the other end of the cable to an Ethernet Broadband

Router or Switch.

Note: You also have the option of connecting the DWL-00AP directly

to the computer that will be used for configuration. The LAN LED light

should illuminate to indicate a proper Ethernet connection. (Note: The

Ethernet Port on the DWL-00AP is Auto-MDI/MDIX. This allows you

to use a straight-through or crossover Ethernet cable to connect to the

Ethernet port on the DWL-00AP.)

Installation

192.168.0.50

with a Subnet Mask of 255.255.255.0.

Table of Contents