Master PULL User Manual page 21

B. Do not ride near motor vehicles.
C. Practice braking in a safe environment.
D. Never ride near steps, sloped driveways, hills, roadways, alleys, swimming pool
areas or other sides of water.
E. Never ride the bike in wet weather. Wet surfaces may increase stopping distance
when braking.
F. Do not ride at night.
G. Don't ride too close to pedestrians.
H. Avoid hazards which may hinder your ability to control your Bike. Potholes, ruts,
uneven pavement, storm grating, gravel, curbs, leaves, puddles and debris can all have
an effect on your riding and result in loss of control.
I. Do not ride off road or on rough pavement.
J. Keep both hands on the handlebar.
CAUTION: BRAKE GENTLY TO AVOID SUDDEN STOPS.
Remove the bike from box and check for any missing or damaged parts.
Steps:
1. Assemble the front fork and the frame. Insert the fork tube into the front pipe of the
frame and tighten the bolts with a wrench.
2. The Rear Wheel may come pre-installed. Of the two bolts on the wheel axle, tighten
the inner bolt first, insert the axle into the slot of the rear frame end, install the tab
washer and tighten the outer bolt firmly.
3. The Front Wheel is installed in the same way as the Rear Wheel.
4. Put the plastic cover on the seat post bolts, insert the saddle post and tighten the
bolts.
5. Put the plastic cover on the handle bar bolts, insert the handle bar stem and tighten
the bolts.
6.
Adjust hand brakes. Loosen the anchor bolt nut on the right part of the
ASSEMBLY INSTRUCTIONS
21
EN