Keycard Theft Protection System; Putting The Unit Into Operation; Removing The Keycard; Training" A Second Keycard/Replacing A Keycard - Blaupunkt STOCKHOLM RCM 128 Operating Instructions Manual

KeyCard theft protection system

This car radio is supplied with one KeyCard
as standard, though it can also be operated
with a second card.
If you have lost your KeyCard or if it was
damaged, you can buy a new one from your
specialised dealer.
When using two KeyCards, the settings
stored on the first card will be adopted.
However, you can individually store the fol-
lowing functions:
Preset button assignments, bass, treble,
balance and fader settings, Loudness, TA
(traffic announcement volume), beep vol-
ume.
In addition, the settings activated before
switching the radio off, such as the wave-
band, station, TA priority, AF, REG ON/OFF,
SCANTIME, seek tuning sensitivity and VOL
FIX will also remained stored.
This ensures that you will find your basic
settings re-adjusted automatically as soon
as you have inserted your KeyCard.

Putting the unit into operation

• Turn on the set.
Introduce the KeyCard into the slot
with the contact area showing up
(KeyCard tongue sticking out).
The car radio is now ready for operation.
If a wrong KeyCard is inserted, then "CARD
40
ERR" will appear in the display. In this case
please do not make any further adjustments.
The system will switch off after approxi-
mately ten seconds.
When inserting another card type (e.g.
phone or credit card), the display will show
"WRONG KC" for approximately two sec-
onds.
Remove the wrong card and introduce the
correct KeyCard.
After the display indications "CARD ERR"
or "WRONG KC":
• Press ON to turn on the set.

Removing the KeyCard

Never pull out the KeyCard directly!
• First, slightly push in the KeyCard.
This releases the card and puts it in the
proper position for being removed.
• Now you can pull it out.
"Training" a second KeyCard/
Replacing a KeyCard
While operating the unit with the first Key-
Card, you can "train" a second one to be
also used with the set:
• Insert the first KeyCard and turn on the
set.
• Press the DSC button and select
"LEARN KC" with / .
• Press << or >>.
The display will switch to "CHANGE".
• Push in the KeyCard. The card is re-
leased and put in the proper position
for being removed.
• Remove the first KeyCard and insert
the new one while "CHANGE" is still
being displayed.
After the display indication "READY" or
"LEARN KC",
• press DSC.
Now you can also use the new KeyCard for
operating your unit.
A maximum of two cards can be used for
the set.
When trying to "train" a third one, the ac-
cess authorisation for the KeyCard not used
for the "training" process will be deleted
automatically.

Displaying the radio pass data

Using the KeyCard supplied with your set
you can have the radio pass data such as
the model name, product number (7 6 ...)
and serial number indicated on the display
panel.
Please refer to chapter "DSC programming
- READ KC".