TP-Link TL-R460 User Manual page 42

Trigger Port - This displays the port for outgoing traffic. An outgoing connection
using this port will "Trigger" this rule.
Trigger Protocol - This displays the protocol used for Trigger Ports, either TCP,
UDP, or All (all protocols supported by the router).
Incoming Ports - This displays the port or port range used by the remote system,
they are used for responding to the outgoing request. A response using one of
these ports will be forwarded to the PC that triggered this rule. You can input at
most 5 groups of ports (or port section). Every group of ports must be apart with ",".
For example, 2000-2038, 2050-2051, 2085, 3010-3030.
Incoming Protocol - This displays the protocol used for Incoming Ports Range,
either TCP or UDP, or ALL (all protocols supported by the router).
Status - This displays the status. Enabled means that the rule will take effect,
Disabled means that the rule will not take effect.
Once configured, the operation for Port Triggering will proceed as follows:
Step 1: A local host makes an outgoing connection using a destination port number
defined in the Trigger Port field.
Step 2: The router records this connection, opens the incoming port or ports associated
with this entry in the Port Triggering table, and associates them with the local
host.
Step 3: When necessary, the external host will be able to connect to the local host using
one of the ports defined in the Incoming Ports field.
To add/modify a port triggering entry:
Step 1: Click Add New.../Modify shown in Figure 4-22, you will see a new screen
shown in Figure 4-23.
Step 2: Select the application you want from the "Common Applications", then the
Trigger port and Incoming ports will be added to the corresponding field
automatically, you only need to configure the Trigger protocol and Incoming
Protocol for the entry; If the "Common Applications" does not contain the
TL-R460 Cable/DSL Router User Guide
Figure 4-22
35