Command And Control Devices; Safety Devices - CAME BXV04AGS Installation Manual

Command and control devices

1 Antenna with RG58 cable
STOP button (NC contact)
2
It stops the gate and excludes automatic closing. Use a control device to resume movement.
If the contact is not used, it must be deactivated during programming.
3 Control device (NO contact)
OPEN ONLY or PARTIAL OPENING function
Fully or partially open the gate.
When the [HOLD-TO-RUN] function is active, the control device must be connected during OPENING.
4 Control device (NO contact)
OPEN-CLOSE (step-by-step) or OPEN-STOP-CLOSE-STOP (sequential) function
When the [HOLD-TO-RUN] function is active, the control device must be connected during CLOSING.
5 Card reader
6 Transponder selector switch
7 Keypad selector
1

Safety devices

Connect the safety devices to the CX, CY and/or CZ inputs (NC contacts).
During programming, configure the type of action that must be performed by the device connected to the input.
If contacts CX and/or CY are not used, they must be deactivated during programming.
DELTA photocells
Standard connection
1 1
+ -
10 11 NO C NC
RX
1 2 3P 7
2 3
2 2 3P 3P 7 7 10 TS 2 CX CY FC FC FA F F FA
+ -
10 11
TX
4
5
DELTA photocells
Connection with safety test
See function F5, safety devices test.
+ -
10 11 NO C NC
S1 GND
A B A B GND A B GN B
7
6
1 1 2 2 3P 3P 7 7 10 TS 2 CX CY
RX
D
FC FC FA F F FA
+ -
10 11
TX