Panasonic CF-19ADUAX M Series Service Manual page 42

■ Line Processing of Antenna Cable and LCD Cable
Step1
LCD Rear Side
Cable Guide Hinge
Insert the red-circled part into between the Cable and the Hinge.
Insert the jig into between
the Cable and the Hinge,
and then process.
Allow some Cable margin.
Jig
(Avoid tension.)
Step3
Set the Holder as shown.(until it clicks)
Ensure the Cable does not
S2 Safety work
come off from the Holder to
avoid catching the cable
between the Holder and Hinge.
Step5
Wrap the LCD Cable as shown and process
it in the arrow direction of the Cable Guide.
Attach the Cable Holder and
Cable Guide Hinge to the Hinge.
<Steps>
1) Inserted into the shaft between
Cable and Hinge jig
2) Wrap the ANT Cable round in 1) above
3) Remove the jig, Wrap the LCD Cable round
Safety work
The red mark
must be on Step4
the Holder.
The black
mark must be
on the Holder.
Step2
LCD Front Side
Cable Holder
To avoid wiring
damage
S5
Step6
7-20
Screen side
Cable Holder Cable Holder Cable Holder
Insert the ANT Cable and LCD Cable to the
Cable Holder as shown.
*Arrange blue/black/brown(or green) to
the left side of the LCD Cable and arrange
white/gray to the right side of the LCD Cable.
S1: S2:
S4: S5:
S1:Insulation S2:Pinching Cables
CAUTION
S3:Sharp Edge S4:Check Parts NO. S5:Others
Front view
LCD Cable arrangement zone
ANT Cable arrangement zone
Wrap the ANT Cable only as shown and process it to
the right side of the rib at the right side of the Cable
Guide.
*Process the LCD Cable as shown and make sure it
does not intersect the ANT Cable.
Check the Cable arrangement.
OK
NG
Make sure that the ANT Cable does not
intersect the LCD Cable.
S3:
S5
Safety work
To avoid wiring
damage