Toshiba W-717 Owner's Manual page 38

®
DSS Satellite Receiver Set-up (continued)
38
6
Select "CONTROL" using PLAY/x2 or STOP , and set to "O
or "OFF" using FF or REW .
N
O : if your DSS ® satellite receiver is
remote-controllable.
• Satellite channels will be selected by
CH (CABLE BOX) on the remote
control.
The VCR can change the satellite
channel to the desired one when timer
recording starts.
Go to step 7.
®
OFF: if your DSS
NON remote-controllable.
• Satellite channels will be selected by
the own channel selector of the DSS
satellite receiver.
The VCR channel should be set to the
output channel of the DSS
receiver.
Go to step 8.
7
Select "BRAND TYPE" using STOP , and enter a brand code
®
of your DSS satellite receiver using number buttons . Refer
to the table on the next page.
Example: For a TOSHIBA DSS
number 99.
USE no C. Box
OUTPUT CH 3
n
CO TROL Off
n
BRA D TYPE no. 99
TO SET BRAND TYPE
PUSH 0~9 KEYS
Make sure that the background of the above display has changed to
the satellite program on channel 200. If not, relocate the DSS
satellite receiver on the VCR so that it can receive the infrared signal.
8
Press PROG . twice to exit.
Notes
• If your satellite channel does not change to 200 in step 7, the DSS
receiver will not be able to change channels in the timer recording. In this
case, set "CONTROL" to "OFF" in step 6.
3
• The VCR Plus+ C system recording is not available on satellite channels.
®
• The DSS ® satellite receiver control is not compatible with the cable box
control.
satellite receiver is
®
®
satellite
®
satellite receiver, identified by
DSS
CH
on
n
"
USE no C. Box DSS
OUTPUT CH 3 CH
n
CO TROL Off on
n
BRA D TYPE no. 36
USE no C. Box DSS
OUTPUT CH 3 CH
n
CO TROL Off on
VCR display
®
®
satetllite