Blaupunkt RDM 127 Operating Instructions Manual page 35

Checking TIM times:
The TIM time of the timer marked by a highlighter bar will appear in the display
header.
If you want to see the time set for the other timer,
• press the corresponding key
Setting TIM times:
You can set the TIM times for TIMER 1 and TIMER 2 in the TIM menu. The
timer which you can programme will be highlighted. TIMER will appear in the
display header along with the preset time.
• Select TIMER 1 or TIMER 2
• Alter the hours by pressing
- MIN / MIN +
by pressing
Alter the other TIM time if necessary. After completing the settings, exit the TIM
menu by
pressing EXIT
• .
Recalling stored traffic messages
• Press TIM briefly or press SRC on the remote control for approximately
1 second.
The display will indicate the recorded traffic messages T1 to T4 with each of the
corresponding recording times.
The messages will be played back automatically, starting with T4, T3, T2 and T1,
depending on how many messages have been recorded. If no messages have
been recorded, NO TIM MESSAGE will appear in the display panel.
Calling up specific messages:
You can call up any of the individual messages by
• pressing the corresponding key
DEUTSCH ENGLISH
or .
.
- HOURS / HOURS +
.
.
FRANÇAIS ITALIANO
S
and the minutes
S
NEDERLANDS
TIMER 1 07:00
- HOURS HOURS +
- MIN MIN +
TIMER 1 TIMER 2
ACTIVE
TIM NDR 2
T4 08:27
T3 08:00 REVIEW
T2 07:27
T1 07:01
SVENSKA ESPAÑOL
CD - Betrieb (Option)
EXIT
CUE
EXIT
35
PORTUGUÊS