Toshiba Strata DK 16 Installation And Maintenance Manual page 291

STEP
1 Enter Program Mode
At the >MODE prompt, enter P R O G CR.
2 Enter Program Number 78
Press CR.
3
Refer to the System Record Sheet and enter the feature number
for the feature to be programmed.
Example: Feature code 1, enter 1.
4 Refer to the System Record Sheet and enter the code number
for the area of the feature being programmed.
Example: Code 3, enter 3.
5 Refer to the System Record Sheet and enter the CO line buttons
that will be associated with this feature.
Example: CO button 01, enter 0 1.
The system will designate whether the CO button/LED is on/off.
Refer to the System Record Sheet and change if required.
Press SPACE to display next CO button/LED.
6 To Exit Program/Store Data
To store data, press CR.
A)
B) Continue returning to step 3 until all data has been entered
for this program.
To exit this program, press # # CR.
C)
NOTE:
Program 79 uses Type 2 procedure.
REMOTE ADMINISTRATION AND MAINTENANCE PROCEDURES
TABLE RM-AK
PROGRAM 78
CO LINE SPECIAL RINGING ASSIGNMENTS-DISA/IMDU/
NIGHT RINGING OVER EXTERNAL PAGE
ACTION
>MODE PROG
P
P 78
P78
P78 1
P78 13
P78 13 01 N
P78 13 01 N
P78 ##
P
-41-
SECTION 100-816-600
MARCH 1993
DISPLAY/PRINTOUT
02 N Y
02 N Y