Table of Contents
Advertisement
Basic Setup
D: Remote control settings (Continued)
Operating the second and third TOSHIBA HDD/DVD video recorders with the remote control of this recorder
Switches the codes to operate the recorder.
If you use the second and third TOSHIBA HDD/DVD video recorders, set the different remote codes for each
recorder to avoid confusion in the response of the recorders.
Example: Setting this recorder's remote control mode to DR 2, after another HDD/DVD recorder has been
set to DR 1.
(It is necessary to set the remote control mode on both the recorder and the remote control.)
Start
46
Setting up the recorder
1
Press SETUP.
The setting menu appears.
SETUP
2
Press
/
to select "Operational settings",
then press ENTER.
e.g.
ENTER
Operation beep
Recording complete beep
IR code
Instant skip interval
Instant replay interval
Title thumbnail point
HDD/RAM title play
Still group interval
Priority contents
3
Press
/
to select "IR code", then press
ENTER.
e.g.
ENTER
Operation beep
Recording complete beep
IR code
Instant skip interval
Instant replay interval
Title thumbnail point
HDD/RAM title play
Still group interval
Priority contents
4
Press
/
to select "DR 2" (example), then
press ENTER.
The submenu disappears.
Press ENTER button and the IR code you selected is
activated. Operation may not be possible temporarily until
ENTER
you set the corresponding mode of the remote control.
Proceed to the next setting.
Operational settings
Off
On
DR 1
30
sec.
10
sec.
35
sec.
Title resume
3 sec.
Photo
SETUP
Operational settings
Off
On
DR 1
30
sec.
10
sec.
35
sec.
Title resume
3 sec.
Photo
SETUP
DR 1
DR 2
DR 3
Advertisement
Table of Contents
