Toshiba TLP780U Owner's Manual page 36

Correcting the keystone distortion (continued)
Remote control
INPUT ON/STANDBY
LASER
AUTO
KEYSTONE
SET
L-CLICK R-CLICK
VOLUME/ADJUST
4,5
6
MENU ENTER EXIT
PIP FREEZE
RESIZE
CALL MUTE
Control panel
(Main unit side)
ON / STANDBY
VOL / ADJ
4,5 6
4
When screen is not installed vertically,
"Auto. V-keystone" is not corrected
properly.
After confirming that "V-keystone" is selected on the menu;
Adjust the distortion of the both sides (right and
left) of the picture with the selection button (
When the projector is not installed with the angle of 90 to the screen
5
viewing from the top, the upper and lower sides of the projected
picture are distorted.
The angle range of
approximately +/-10 to 90 is
adjustable.
Select "H-keystone" from the menu with the
selection button (
distortion of the upper and lower sides of
the picture with the selection button (
EXIT
6
Press EXIT repeatedly until the menu disappears.
The keystone adjustment finishes.
EXIT
Notes
• Due to digital correction processing, some of the information may dropped or the picture quality may
be degraded depending on the keystone correction setting or the contents of the signal source.
• The adjustable range of "V-keystone" or "H-keystone" is influenced by the quantity of correction
of each other.
• When "Auto. V-keystone" does not operate properly even with the screen installed vertically,
52
execute "H-reference reset"
90
), and adjust the
/
.
36
CONTENTS
).
/
).
/