Preparing And Using The Remote Control - Toshiba TDP-S9 Owner's Manual

Preparing and using the remote control

■ Loading a Lithium battery
into the remote control
1 Push and slide the battery
compartment lid.
2 Install a Lithium battery.
Be sure to align the polarity of the
battery properly.
3 Position the lid over the
compartment and snap it back
into place.
Lithium battery
• Before using the battery, be sure to observe the Safety Precautions described in previous pages.
• Remove the battery from remote control when not using for extended periods.
The remote control
• The remote control may fail to operate if the infrared remote sensor is exposed to bright sunlight or
fluorescent lighting.
• Do not drop or bang.
• Do not leave in hot or humid locations.
• Do not get wet or place on top of wet objects.
• Do not take apart.
• In rare cases, ambient conditions could impede the operation of the remote control. If this happens,
point the remote control at the main unit again, and repeat the operation.
1
2
■ Operating the remote
control
Point the remote control toward the
projector's infrared remote sensor,
and press a button on the remote
control.
• Operating the projector from the front
• Operating the projector from the rear
18