Stopping The Engine; Checking The Saw; Checking The Chain Sprocket - Stihl MS 194 T Instruction Manual

10 Checking the Saw

► Press down the throttle trigger lockout (3) and hold it
there.
► Pull the throttle trigger (4) and hold it there.
► Move the Master Control lever (2) to position
► Stand the saw on a level surface.
► Hold the trimmer firmly with your right hand on the top
handle – wrap your thumb around the handle.
► Press the saw against the ground with your right hand.
► Hold the saw steady with your right knee on the shroud.
► Pull the starter grip slowly with your left hand until you feel
it engage.
► Pull the starter grip quickly and allow the starter rope to
rewind several times until the engine runs.
► Press down the throttle trigger lockout (3) and hold it
there.
► Blip the throttle trigger (4).
The Master Control lever (2) springs to position . The
engine runs at idling speed.
NOTICE
Do not accelerate the engine with the chain brake engaged
since this can damage the chain brake.
► Disengage the chain brake before you start cutting.
► Disengage the chain brake.
Your saw is ready for operation.
0458-568-0121-A
► If the saw chain rotates while the engine is idling: See
troubleshooting.
Idle speed adjustment is not correct.
► If the engine does not start: Prepare the engine for the
.
start and then try again to start the engine.
9.4

Stopping the engine

► Release the throttle trigger (3) and lockout lever (2).
The saw chain stops running.
► Move the Master Control lever (1) to position
The engine stops and the Master Control lever (1) springs
back to position .
If the engine does not stop:
► Move the choke lever to position
The engine stops.
► Do not use the chainsaw and contact your STIHL
servicing dealer for assistance.
The Master Control lever is defective.
10 Checking the Saw

10.1 Checking the Chain Sprocket

► Shut off the engine.
► Disengage the chain brake.
► Remove the chain sprocket cover.
1
2
3
.
English
.
21