Names Of Each Part On The Control Panel And Remote Control; Parts On The Rear Panel - Toshiba TDP-MT400 Owner's Manual

Names of each part on the control panel and remote control

Control panel
(9) (10) (11)
(1)
(8)
(7) (2)
(3)
(6)
(4)
(5)
Name : Main Function
(1) ENTER button : Accepts the selected mode.
(2) MENU button : Displays menus.
(3) SET UP button : Sets up image and mode.
(4) ON/STANDBY button : Turns the power on/off (standby).
(5) ON indicator : Displays whether power is on or off.
(6) INPUT button : Selects input.
(7) RETURN button : Goes back one screen.
(8) Selection button : Menu selections and adjustments,etc.
(9) LAMP indicator : Displays lamp mode.
(10) TEMP indicator : Lights when internal temperature is too high.
(11) FAN indicator : Displays cooling fan mode.
(12) FREEZE button : Pauses image.
(13) MUTE button : Cuts off the picture temporarily.
Note
• For the remainder of this manual, buttons are referred to as follows:
Selection buttons ⇒ ; ENTER button ⇒
Remote Control
Remote control
transmitter
(4)
(3)
(6) (2)
(12)
(13)
(1)
(8)
(7)
p.28
p.25
p.21
p.21
p.23
p.29
p.22
p.36
p.36
p.27
p.27
16
English Français Español

Parts on the rear panel

(1) (2) (3) (4)
(10)
Name : Main Function
(1) Infrared remote sensor : Senses commands from the remote control.
(2) CONTROL terminal : When operating the projector via a computer, connect
this to the controlling computer's RS-232C port.
(3) S-VIDEO terminal : Input S video signals from video equipment.
(4) VIDEO terminal : Input video signals from video equipment.
(5) Component video terminal : Input component video signal (Y/P
equipment or other source.
(6) COMPUTER terminal : Input RGB signal from a computer or other source.
(7) DVI-D terminal : Input digital RGB signal from a computer or other
source.
(8) Main power switch : AC power line ON (standby)/OFF.
(9) AC IN socket : Connect the supplied power cord here.
(10) Antitheft lock hole : Attach a safety cable or any other antitheft device.
Notes
• Although this owner's manual abbreviates component video signals as Y/P
product also supports signals from video equipment marked "Y/C
• Input signal specifications for the DVI terminal complies with the DVI 1.0 Specifications.
• Please note that the operations for the functions not covered in these specifications are
not guaranteed. Because this is an evolving technology, it is possible that some devices
may not operate properly with the projector.
• This supports HDCP (High-bandwidth Digital Content Protection).
Deutsch Italiano Português Svenska
(7)
(5) (6)
(9) (8)
p.18
/P ) from a video
B R
/P , the
B R
/C ."
B R
17
p.43