Connection; Turning The Power On And Off - Toshiba TDP-MT400 Owner's Manual

Connection

Before connection
• Read the owner's manual of the device you are connecting to the projector.
• Some types of computer cannot be used or connected to this projector.
Check for an RGB output terminal, supported signal
• Turn off the power of both devices before connecting.
• The figure below is a sample connection. This does not mean that all of these devices
can or must be connected simultaneously. (Dotted lines mean items can be exchanged.)
Computer (for control)
Video recorder,
DVD player, etc.
To S-Video
To RS-232C
output
p.43
terminal
S-Video cable
Control cable
(supplied)
RGB component video cable
(not supplied)
To Y/C /C output
B R
Green (Y)/Blue (C )/Red (C
B
DVD video recorder, etc.
Notes
• If you want to feed the digital RGB signal, separately available DVI cable is needed.
• If you are using the digital RGB signal for input to this unit, some computer models or a
certain type of DVI cable may cause on rare occasions noise on the screen. If such is a
case, decrease your computer's refresh rate or the resolution. It is also recommended to
use a DVI cable in 2 m or less in length.
p.39 , etc.
VCR, etc
To video
output
Video cable (supplied)
DVI cable
(not supplied)
RGB cable
(not supplied)
)
R To DVI output
To RGB output
Computer
Computer
20
English Français Español

Turning the power on and off

Connecting the power cord
1
Insert the power cord connector into the
AC IN socket of the projector.
2
Insert the power cord plug into a wall or
other power outlet.
Removing the lens cover
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
Turning the power on
1
Turn on the main power switch
The ON indicator will change to
orange, indicating standby mode.
• After the main power switch is turned
on, the inner cooling fan starts
cooling.
2
Press the ON/STANDBY
button.
The power turns on, and the following
3 green indicators light: ON, LAMP,
and FAN. After a moment, the start-up
screen appears.
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheating.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause
burns, deform/break the object.
Deutsch Italiano Português Svenska
Power cord connector
(Supplied)
(Orange)
Remote
Control panel Control Start-up screen
21