Operations; Turning The Power On And Off - Toshiba TDP TDP-TW95 Owner's Manual

Operations

Turning the power on and off

■ Connecting the power cord
1
Insert the power cord connector into
the AC IN socket of the projector.
2
Insert the power cord plug into a
wall or other power outlet.
The ON/STANDBY indicator will
change to orange, indicating standby
mode.
■ Removing the lens cover
Be sure to remove the lens cover when the power is
turned on. If it is left on, it could become deformed due
to heat.
■ Turning the power on
Press the ON/STANDBY
button.
The power turns on, and the following
3 green indicators light: ON/STANDBY,
LAMP, and FAN. After a moment, the
start-up screen appears.
CAUTION
• Do not look into the lens while the lamp is on. The strong light from the lamp may cause
damage to your eyes or sight.
• Do not block the air intake or exhaust. Doing so could cause a fire due to internal overheat-
ing.
• Do not place your hands, face, or other objects near the air exhaust. Doing so could cause
burns, deform/break the object.
Power cord connector
(Supplied)
Remote
Control panel Control
Start-up screen
24
Notes
• The start-up screen will disappear after a moment. You can dismiss the start-up screen
before this by performing any operation. You can also configure the start-up screen not to
appear via the Display setting menu
p.38
• The first time you use the projector after purchase, after the start-up screen disappears,
the start menu is displayed .
p.26
• When [Key lock] is [On], the operation buttons of the projector do not work
• When [Password] is [On], enter password then the start-up screen is displayed after the
Password entry screen disappears
p.33
■ Turning the power off
1
Press the ON/STANDBY button.
A message appears on the screen, confirming that you wish to shut off the power. This
message will disappear after a moment. (This operation is no longer valid after the
message disappears.)
2
Press the ON/STANDBY button again.
The screen turns off, but the internal cooling fan continues to operate for a short while.
Then, the projector goes into standby mode.
When cooling lamp During internal cooling
A B
During cooling, the LAMP indicator flashes. In this state, the power cannot be
A
turned back on.
If you are in a hurry, there is no problem with unplugging the power cord in this
state.
After the LAMP indicator goes off, the FAN indicator keeps lighted and the
B
cooling fan continues to operate for a short while, in order to expel excess
internal heat.
In standby mode
C
Note
• The projector consumes about 9W of power in standby. We recommend that you unplug
the power cord if you will not be using the projector for an extended period.
(When [Wireless standby] is [On], it consumes about 12W during standby.)
PRECAUTION
• If the power cord is unplugged before cooling is complete, give the lamp time (about 5
minutes) to cool before plugging it back in. If the lamp overheats, it may fail to light.
.
p.43
.
After cooling complete
C
25
.