Displaying Tv Setting Information On-Screen Using Recall; Understanding The Auto Power Off Feature; Understanding The Last Mode Memory Feature; Using The Gray Level Feature - Toshiba 52HMX95 Owner's Manual

Displaying TV setting information
on-screen using RECALL
To display TV setting information on-screen:
Press RECALL on the remote control.
The following information will display on-screen (if applicable):
• Current input (ANT 1, ANT 2, VIDEO 1, etc.)
• If ANT 1 or ANT 2 is the current input, whether it is
Cable TV ("CABLE") or
STEREO
off-air ("TV")
NC-17
• Channel number (if in
On Timer: Weekdays 12:00pm
ANT 1 or ANT 2 mode)
Sleep Timer: 18 min.
Game Timer: 28 min.
• Signal strength indicator
(bar graph in lower right
Natural
1080i
corner of screen; for
ATSC signal only)
Note: The signal strength indicator will react to fading and
increasing signals.
• Time (if set)
• On/Off timer settings (if set)
• Remaining time on sleep timer (if set)
• Remaining time on game timer (if set)
• Stereo or SAP audio status
• V-Chip rating status
• Picture size
• Tuner hold* (if applicable)
*If you are recording on one tuner (for example, the digital
tuner), you will be able to change channels on the other tuner
only (the analog tuner in this example). The tuner from which
you are recording is "on hold" (i.e., locked) so your
recordings will not be affected by channel changes.
• Video resolution
• Lamp mode (appears only if the TV is in Hi Bright mode)
To close the RECALL screen:
Press RECALL again.
96
Chapter 8: Using the TV's features
Understanding the auto power off
feature
The TV will automatically turn itself off after approximately 15
minutes if it is tuned to a vacant channel or a station that
completes its broadcast for the day. This feature functions in
ANT 1 and ANT 2 modes only.
Tuner Hold: On
Understanding the last mode
memory feature
ANT 1
If the power is cut off while you are viewing the TV, the Last
81-1
5:32pm CABLE
Mode Memory feature automatically turns on the TV when
Sample RECALL screen
the power is resupplied.

Using the Gray Level feature

The gray level feature will set the sidebars to three different
levels of darkness. Sidebars are the blanks spaces on either side
of a 4:3 viewing area.
To set the gray level of the sidebars:
Copyright © 2005 TOSHIBA CORPORATION. All rights reserved.
Note: You should unplug the TV's power cord if it is possible
that you will be away from the TV for an extended period of time
after the power is restored.
1. Press MENU and open the Setup menu.
2. Highlight Gray Level and press •.
3. Press y or z to select your desired level of darkness
(1 – Black, 2 – Dark Gray or 3 – Gray).
Setup
PC Settings 1
Auto Auto
HDMI 1 Audio On 2
HDMI 2 Audio Auto Auto Auto 3
Slide Show Interval 2 Sec
AVHD Skip Time 15 min
Gray Level 2
Quick Restart On
Navigate Back Exit
Select CH RTN EXIT
Note:
• The gray level feature does not affect video being viewed in 16:9
aspect ratio.
• When receiving a signal that has sidebars (e.g., 4:3 aspect ratio
video over a 1080i or 720p signal), the gray level feature will not be
applied to the sidebars.