Led Indications - Toshiba 50HM67 Owner's Manual

50HM67_EN.book Page 62 Thursday, March 29, 2007 11:28 AM

LED indications

The yellow, blue, and red/green LED lights on the TV (at the bottom center of the TV) indicate the TV's status, as described below.
Note: If the TV loses A/C power (e.g., a power outage occurs or the power cord is unplugged), when power is restored, the yellow
LED will blink while the TV is booting until the remote control is usable. This is normal and is not a sign of malfunction.
TV front
Yellow LED
LED Indication
1) Blue is ON (solid).
2) Green is ON (solid).
3) Yellow blinks.
4) Blue is ON (solid).
Yellow blinks.
5) Yellow is ON
(solid). Red blinks.
6) Yellow is ON
(solid).
7) Red blinks.
8) Blue blinks slowly.
Red blinks.
9) Blue blinks slowly.
10)Blue blinks quickly.
11)Blue blinks quickly.
Red blinks.
12)Blue blinks quickly.
Yellow blinks.
Red blinks.
If, after trying the solution, the problem still exists:
In the U.S., call TACP Consumer Solutions at 1-800-631-3811.
•
In Canada, locate the nearest Toshiba authorized service depot by directing your web browser to www.toshiba.ca; click
•
"Home Entertainment," and then click "Support."
62
Chapter 8: Troubleshooting
"Voice announce" feature
When certain non-standard conditions occur, the LEDs
on the TV will blink and the TV will play a recorded
"voice announcement" describing the condition (see the table below
for the specific conditions that include a voice announcement).
To repeat the voice announcement and hear additional information,
Blue LED Red/Green LED
press the MENU button on the TV while the LEDs are blinking.
Condition
The TV is operating
–
properly.
Power-On Mode Fast.
See "Setting the Power-On Mode feature" (- page
Standby with Power-On
35).
Mode Fast.
The lamp is not working The TV will automatically try to restart itself eight times
properly. (see item #4).
Note: If the TV is powered off and then quickly on again
when the lamp unit is hot, it may take several minutes
for the picture to appear on-screen. This is a property of
®
DLP
malfunction. For details, see "Setting the Power-On
Mode feature" and "IMPORTANT NOTICE ABOUT
HOT LAMP RESTART" (- page 35).
The lamp is not working Turn the TV OFF and then ON again. If the problem
properly after the eighth persists, contact TACP Consumer Solutions at 1-800-
automatic restart (see 631-3811 in the U.S. or TCL Customer Service at
item #3). 1-800-268-3404 in Canada.
The lamp unit door is not Turn OFF the TV and unplug the power cord. Review
seated properly. "Lamp unit replacement and care" in Chapter 9 to
ensure that the lamp door is installed securely.
Fan stopped.
Abnormal operation of
BUS line. (light engine).
Abnormal operation of
Turn OFF the TV and unplug the power cord. Plug the
BUS line.
power cord in again and turn ON the TV.
Power Protect
Detection.
The color wheel has
stopped.
An abnormal Turn OFF the TV. Check to make sure none of the slots
temperature increase or openings in the TV cabinet are covered, blocked, or
has occurred. dusty. Turn ON the TV again.
Solution
TV lamp technology and is NOT a sign of
Voice
Announce
–
–
–
"Lamp not
working"
"Lamp door is
open."
"Fan stopped."
–
–
–
"Color wheel
stopped."
"Temperature
warning."
HM67 (E/F) Web 213:276