Adjusting The Color Convergence - Toshiba 43H71 Owner's Manual

Adjusting the color convergence

This projection TV uses three separate TV tubes: red, green, and blue.
The red, green, and blue images are projected onto the screen where
they converge to form a full-color picture. You can see a clear picture
only when the three images converge correctly. Convergence may drift
over time or if you move the TV. If you can see clear images on your
TV screen, skip this procedure.
Make this adjustment only after the TV has been on for at least 30
minutes.
To use the TOUCH FOCUS (auto-convergence) button:
Press TOUCH FOCUS on the TV once. The TV will enter the
auto-convergence mode and adjust the convergence
automatically.
TOUCH FOCUS
TOUCH FOCUS F I N I SHED
When the adjustment is complete, the normal picture reappears.
If the error message "Touch Focus Error" appears, retry the
TOUCH FOCUS adjustment or adjust the convergence
manually, as described below.
To check and adjust the color convergence manually:
1. Press MENU, and then press x or • until the PICTURE menu
appears.
2. Press y or z to highlight CONVERGENCE.
P CTURE ANTENNA I
MODE SPORTS
FLESH TONE ON
DNR OFF
C I NEMA MODE F I LM / V I DEO
COLOR
TEMPERATURE COOL
CONVERGENCE
PREFERENCE
SAVE NEW
H orizontal
B G R
Ver tical
43H71
CH
MENU VOL VOL EXIT
TV/VIDEO TOUCH FOCUS
CH
MENU yzx •
TOUCH FOCUS
53H71/61H71
CH
MENU EXIT TV/VIDEO TOUCH FOCUS
VOL VOL
CH
MENU yzx •
TOUCH FOCUS
LIGHT RECALL POWER
CTV
CABLE
MUTE TV/VIDEO TIMER
VCR
1 2 3
CH
4 5 6
7 8 9
VOL
CH RTN
0
100
ENT
ADV/
PIP CH
MENU
MENU/
FAV FAV
ENTER
yzx •
ADV/
PIP CH
PLAY PIP
STOP SOURCE
REC TV/VCR REW FF
STILL LOCATE SWAP
PO
POWER
21