Advertisement
CAUTION:
v Do not install a unit in a rack where the internal rack ambient temperatures will exceed the
manufacturer's recommended ambient temperature for all your rack-mounted devices.
v Do not install a unit in a rack where the air flow is compromised. Ensure that air flow is not
blocked or reduced on any side, front, or back of a unit used for air flow through the unit.
v Consideration should be given to the connection of the equipment to the supply circuit so that
overloading of the circuits does not compromise the supply wiring or overcurrent protection. To
provide the correct power connection to a rack, refer to the rating labels located on the equipment
in the rack to determine the total power requirement of the supply circuit.
v (For sliding drawers) Do not pull out or install any drawer or feature if the rack stabilizer brackets are
not attached to the rack. Do not pull out more than one drawer at a time. The rack might become
unstable if you pull out more than one drawer at a time.
v (For fixed drawers) This drawer is a fixed drawer and must not be moved for servicing unless
specified by the manufacturer. Attempting to move the drawer partially or completely out of the
rack might cause the rack to become unstable or cause the drawer to fall out of the rack. (R001 part
2 of 2)
To install the appliance on the slide rails, complete the following steps as shown in Figure 5:
1. Pull the slide rail forward 1 .
2. Use one or two people (depending on your appliance model) to carefully lift the appliance 2 and
tilt it into position over the slide rails so that the rear nail heads 3 on the appliance line up with the
rear slots 4 on the slide rails.
3. Slide the appliance down until the rear nail heads slip into the two rear slots, and then slowly lower
the front of the appliance 5 until the other nail heads slip into the other slots on the slide rails.
4. Make sure that the front latch 6 slides over the nail heads.
Figure 5. Secure the appliance in the rack
5. If the appliance is locked into place, slide the appliance toward you so that you can attach the
brackets with the captive screws.
6. Slide the appliance into the rack, as shown in Figure 6 on page 6.
Lift point
Lift point
5
Advertisement
