Advertisement
Figure 1. View of the slide rails
2. Install the rear end of the slide rails, as shown in Figure 2.
a. From the front of the rack, line up the three pins on the rear of the slide rail with the three holes
in the selected U on the rear of the rack.
b. Push the rails so that the pins go into the holes 1 , and latch down into place 2 until it latches
into place.
Note: If you are installing the slide rails into a space with devices already installed directly above
and below, you must extend the slide rails to slide the rear of the slide rails into the rear of
the rack.
Rear Rack
Figure 2. Install the rear end of the slide rails
3. Install the front end of the slide rails, as shown in Figure 3 on page 3:
a. Pull the slide rail forward and insert the two pins 1 on the front of the rail into the two lower
holes in the U on the front of the rack.
b. Drop the rail into place until it clicks. Push the front latch 2 in all the way.
c. Repeat steps 1 through 3 to install the other rail into the rack. Make sure that each front latch is
fully engaged.
2
3
Advertisement
