Table of Contents
Advertisement
Operation
Operation
1. Ensure MaxiVac motor switches are turned to
"OFF". Plug vacuum into grounded power source.
2. Turn Auto Filter Cleaner Power Switch to "ON".
Ensure the sound of the Filter Cleaner Bar is heard
contacting the inside of the filter. If no sound is
heard, replace the Plastic Inserts on the cleaning
bar. See page 17.
3. After 10 seconds, turn on a Vacuum Motor Switch.
Turn on additional vacuum motors if needed.
4. MaxiVac is now ready for dust collection from the
GrindLazer or other removal equipment.
8
Emptying Collection Tanks
DUST HAZARD
Grinding concrete and other surfaces can create dust
that contains hazardous substances. To reduce the
risk of serious injury:
•
Respirator must be worn when emptying or
cleaning Dust Collection Tanks or bags.
•
Follow local ordinances and regulations for
disposal.
1. When Dust Collection Tanks are full, turn off all
vacuum motors. Turn Auto Filter Cleaner power
switch to "ON". After 2 minutes of cleaning the
vacuum filters, turn off cleaning switch and unplug
vacuum from power source.
2. If MaxiVac is full, remove Dust Collection Tank by
pulling up on the Engagement Lever.
3. If Cyclone separator is full, remove the Separator
Lid.
4. Wearing a respirator, gather and secure the top of
the collection bag. Lift and remove the collection
bag, tie up and then dispose. Follow local
ordinances and regulations for disposal.
5. Insert new bags into the collection tanks and
reinsert the tanks into the Cyclone separator and
into the bottom of the MaxiVac. Ensure the Dust
Collection Tank is securely attached to the body of
the vacuum by pushing down on the Engagement
Lever.
TBD
Advertisement
Table of Contents
