Table of Contents
Advertisement
Quick Links
Operation, Parts
MaxiVac
Vacuum for collection of dry concrete and asphalt dust. For professional use only.
Vacuums
Model MV-360 (120V)
Model MV-600 (230V)
Separators
Model MV-SA (20 gallon)
Model MV-SB (32 gallon)
Important Safety Instructions
Read all warnings and instructions in this manual.
Be familiar with the controls and the proper usage
of the equipment. Save all instructions.
MaxiVac
™
and Cyclones
MV-SA and MV-SB
3A5576
EN
Advertisement
Table of Contents
Related Manuals for Smith MaxiVac MV-360
Summary of Contents for Smith MaxiVac MV-360
- Page 1 Operation, Parts ™ MaxiVac and Cyclones 3A5576 Vacuum for collection of dry concrete and asphalt dust. For professional use only. Vacuums Model MV-360 (120V) Model MV-600 (230V) Separators Model MV-SA (20 gallon) Model MV-SB (32 gallon) Important Safety Instructions Read all warnings and instructions in this manual. Be familiar with the controls and the proper usage of the equipment.
-
Page 2: Table Of Contents
SMITH Standard Warranty ........ -
Page 3: Warnings
Warnings Warnings The following warnings are for the setup, use, grounding, maintenance, and repair of this equipment. The exclamation point symbol alerts you to a general warning and the hazard symbols refer to procedure-specific risks. When these symbols appear in the body of this manual or on warning labels, refer back to these Warnings. Product-specific hazard symbols and warnings not covered in this section may appear throughout the body of this manual where applicable. - Page 4 Warnings WARNING GROUNDING This product must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This product is equipped with a cord having a grounding wire with an appropriate grounding plug. The plug must be plugged into an outlet that is properly installed and grounded in accordance with all local codes and ordinances.
- Page 5 Warnings WARNING EQUIPMENT MISUSE HAZARD Misuse can cause death or serious injury. • Do not operate the unit when fatigued or under the influence of drugs or alcohol. • Do not leave the work area while equipment is energized. Turn off all equipment when equipment is not in use.
-
Page 6: Component Identification
Component Identification Component Identification MV-360 and 330 MV-SA MV-SB Component Auto Filter Cleaner Power Switch Vacuum Motor Switch Vacuum Motor Switch Vacuum Motor Switch (MV-600 only) Motor Housing Assembly Engagement Lever Filter Housing and Body Dust Collection Tank Vacuum Hookup Vacuum Inlet Vacuum Outlet Separator Lid... -
Page 7: Setup
Setup Setup 1. Insert dust collection bags into Dust Collection 2. Connect hoses. Tanks. If using a Cyclone separator: a. Remove Dust Collection Tank by pulling up on • Connect one end of the short vacuum hose to the inlet of the MaxiVac. Connect the other end of the the Engagement Lever and insert the collection short hose to the outlet of the Cyclone separator. -
Page 8: Operation
Operation Operation Emptying Collection Tanks 1. Ensure MaxiVac motor switches are turned to “OFF”. Plug vacuum into grounded power source. DUST HAZARD Grinding concrete and other surfaces can create dust that contains hazardous substances. To reduce the risk of serious injury: •... -
Page 9: Shutdown And Storage
Shutdown and Storage Shutdown and Storage Shutdown Storage 1. Turn off all vacuum motors and leave Auto Filter Disconnect power cord before storing. Store indoors. Cleaner Power Switch to ON. NOTICE Do not store in a location with high temperatures or excessive humidity, in order to prevent damage to your MaxiVac components. -
Page 10: Maintenance
Maintenance Maintenance Weekly • Inspect Filter Ring Seal for damage. If damaged, replace seal. Ensure seals are installed correctly and properly sealed. DUST AND SHOCK HAZARD To reduce the risk of serious injury: • Respirator must be worn during all maintenance. •... -
Page 11: Parts
Parts Parts Main Assembly Diagram (MaxiVac) -
Page 12: Main Maxivac Assembly Parts (Maxivac)
Parts Main MaxiVac Assembly Parts (MaxiVac) Part Number Description See page 13-15 Motor Housing Assembly See page 17 Auto Filter Cleaner Assembly MV.1.891A Filter MV.30 Filter Seal Ring 17X187 Main Frame 17X188 Dust Collection Tank MV.HS Long Vacuum Hose, Standard, 2” (includes item 19) MV.26 Vacuum Extension MV.24... -
Page 13: Motor Housing Assembly Diagram (Mv-360)
Parts Motor Housing Assembly Diagram (MV-360) -
Page 14: Motor Housing Assembly Parts List (Mv-360)
Parts Motor Housing Assembly Parts List (MV-360) Part Number Description AHN.25-20 Acorn Nut CH-PART(L)-04-a Motor Housing Cover (includes IEC power cord) HN.25-20x1.0 Hex Spacer, Long (not shown, located inside item 2) MV.1.07 Set of Motor Rubber Rings and Plastic Net MV.1.06A Motor, 230V HN.25-20x.50... -
Page 15: Motor Housing Assembly Diagram (Mv-600)
Parts Motor Housing Assembly Diagram (MV-600) -
Page 16: Motor Housing Assembly Parts List (Mv-600)
Parts Motor Housing Assembly Parts List (MV-600) Part Number Description AHN.25-20 Acorn Nut CH-PART(L)-04 Motor Housing Cover (includes IEC power cord) HN.25-20x1.0 Hex Spacer, Long (not shown, located inside item 2) MV.1.07 Set of Motor Rubber Rings and Plastic Net MV.1.06A Motor, 230V HN.25-20x.50... -
Page 17: Auto Filter Cleaner Assembly (Maxivac)
Parts Auto Filter Cleaner Assembly (MaxiVac) Part Number Description MV.1.13A Auto Filter Cleaner Assembly Motor Stand MV.3.12B 120V Filter Cleaner Assembly Motor MV.1.12A 230V Filter Cleaner Assembly Motor MV.1.11-C Filter Cleaner Bar, Support (set of 2) MV.1.11-D Filter Cleaner Plastic Inserts... -
Page 18: Mv-Sa Assembly And Accessories
Parts MV-SA Assembly and Accessories... -
Page 19: Mv-Sa Assembly And Accessories Parts List
Parts MV-SA Assembly and Accessories Parts List Part Number Description MV.HS.SD Long Vacuum Hose MV.HS.5 Short Vacuum Hose 17X694 Debris Tank MV.3.20 Dust Bag MV.1.025 Dust Bag Holder MV.30 Cyclone Seal Ring MV.31 Cyclone Ring MV.SB.4 Cyclone Head 17X190 Vacuum Extension 17X191 Vacuum Elbow 17X192... -
Page 20: Mv-Sb Assembly And Accessories
Parts MV-SB Assembly and Accessories... -
Page 21: Mv-Sb Assembly And Accessories Parts List
Parts MV-SB Assembly and Accessories Parts List Part Number Description MV.SAB.01 Lid Funnel 17X207 Lid Rubber Gasket 17X208 M8-1.25x25 mm Hex Head Bolt MV.SB.4 Lid Base 17X210 M8 Fender Washer 17X211 M8 Lock Washer 17X212 M8-1.25 Hex Nut MV.31 Separator Main Body Seal MV.30 Separator Main Body Seal Ring MV.SB.H... -
Page 22: Technical Data
Technical Data Technical Data MV-360 (25M858) Electrical Power Requirements - 120 Vac, 60 Hz, 20 A, 1Ø Air Flow (without hose) - 1 vacuum motor: 135 cfm, 2 vacuum motors: 262 cfm Air Flow (with 2” x 30’ hose) - 1 vacuum motor: 93 cfm, 2 vacuum motors: 178 cfm Filtration - 99.3% at 0.3 μm particle size Dimensions/Weight (unpackaged) Metric... -
Page 23: Smith Standard Warranty
With the exception of any special, extended, or limited warranty published by SMITH, SMITH will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by SMITH to be defective.