Toshiba TOSVERT VF-nC1 Instruction Manual page 51

4.1.5 Parameters that cannot be changed while running
For reasons of safety, the following parameters have been set up so that they cannot be
reprogrammed while the inverter is running.
[Basic parameters]
(Command mode selection)
(Frequency setting mode selection)
(Standard setting mode selection)
(Maximum frequency (Hz))
(Base frequency 1 (Hz))
(V/f control mode selection)
4
[Extended parameters]
(Analog input/logic input function
(Always active function selection (ST))
(Input terminal selection 1 (F))
(Input terminal selection 2 (R))
(Input terminal selection 3 (S1))
(Input terminal selection 4 (S2))
(Input terminal selection 5 (VI/S3))
(Sink/Source selection)
(Output terminal selection 1 (OUT/FM))
(Output terminal selection 3 (FL))
(Base frequency 2 (Hz))
(Base frequency voltage 2 (V))
selection)
Set , and
while the inverter is running.
(DC braking current (%))
(PWM carrier frequency)
(Auto-restart control selection)
(Regenerative power ride-though
control)
(Over voltage limit operation)
(Slip frequency gain)
(Base frequency voltage 1 (V))
(Motor rated current)
(Motor no-load current)
(Motor rated speed)
(Speed control gain)
(Speed control stable coefficient)
(Stall prevention level)
(External input trip stop mode
selection)
(Input phase failure detection
mode selection)
(Under voltage trip selection)
D-10
E6581090
and can be changed