I.link (Ieee1394); Precautions - Toshiba M30 User Manual

User's Manual
7. Turn on the computer.
8. Start the HW Setup program. Refer to Chapter 7,
9. Select the Parallel/Printer tab from the TOSHIBA HW Setup
window.
10. Set the Parallel Port Mode and press OK.
11. Choose Reboot for the change to take effect.
12. Select the printer in Windows Add Print Wizard. To access the Add Print
Wizard utility, click Start, point to Settings, click Printers and double
click the Add Printer icon.

i.LINK (IEEE1394)

i.LINK (IEEE1394) is used for high-speed data transfer for a range of compatible
devices such as
Digital video cameras
Hard disk drives
MO drives
CD-RW drives
NOTE: i.LINK uses a four-pin connector, which does not carry
electric current. External devices will need their own power supply.

Precautions

Make a backup of your data before transferring it to the computer. There is a
possibility that the original data will be damaged. There is a particular risk that
some frames will be deleted in the case of digital video transfer. TOSHIBA
assumes no liability for such loss of data.
Do not transfer data in areas where static electricity is easily generated or in
areas subjected to electronic noise. Data can be destroyed.
If you are transferring data through an IEEE1394 hub, do not connect or
disconnect other devices from the hub during data transfer. There is a likeli-
hood that data will be damaged. Connect all devices to the hub before you turn
on the computer's power.
You may not use any copyrighted video or music data copied from a video
camera except for your personal enjoyment.
8-12
HW Setup.